The linear 15MM bearing is a wide strong support bearing, This bearing fits exclusively on the 15MM railing and comes in a few different types. This 15MM bearing is a specific part...
The linear 25MM bearing is a wide strong support bearing, This bearing fits exclusively on the 25MM railing and comes in a few different types. This 25MM bearing is a specific part...
Bossed nylon gears with 16mm shaft. Three are required for the motion of the Mastercut series of Blackman & White machines; this includes the non-bossed nylon gears. The synthetic polymer from which...
The Gripper Feet Pads are attached to the bottom of the Gripper feet that go along the gantry of the Genesis Machine, holding down any material as it cuts to...
The Emergency Stop Button is essential to run our machines safely, located on the corners of the machine and the control area it instantly stops the machine in the case...
Non-bossed Nylon Gear. The synthetic polymer from which all our nylon gears are made, produces a very low friction coefficient, and they have great wear resistance. All the gears should...
The non-bossed bronze gear X axis gear. For use exclusively with our Genesis-V ranges of machines, it is durable and long lasting to ensure minimal wear and continued effectiveness of the machine...
The linear 20MM bearing is a wide strong support bearing, This bearing fits exclusively on the 20MM railing and comes in a few different types. This 20MM bearing is a specific part...
The Jog button for the machine is used to transfer manual control of the cutting head from the computer using the software to controlling the head via the jog stick....
Genesis Y axis drive belt (top) This tool head belt is for the Genesis tool head, due to natural wear and tear this belt will need replacing on the machine...
The bossed bronze gear Y axis gear. For use exclusively with our Genesis-V ranges of machines, it is durable and long lasting to ensure minimal wear and continued effectiveness of the...
These are a transporter (or storage) for up to 6 super-wide rolls; maximum size 500cm long x 25cm diameter. You can also use three Jumbo Rolls Transporters for heavier rolls...
The micro switch inside the Blackman & White machine range are mostly used as Limit switches and are essential for safe use of the machine. Should you have any issue...
The Jog Stick for the machine is used when manual movement of the machine cutting head is needed. This is set via the Jog Button. should you have issues with...
Genesis Y axis drive belt (bottom) for the genesis Blackman & White cutting machine. This tool head belt is for the Genesis tool head, due to natural wear and tear this...
Delrin Helical Pinion. The synthetic polymer from which all our delrin gears are made, produces a very low friction coefficient, and they have great wear resistance. Helical Pinions are designed...